Please connect the CTM-500 to a suitable power supply. There Below are three options for powering the CTM-500:
DC Power supply (refer to appendix for more detail)
Power over Ethernet (PoE)
Vehicle ECU (OBDII/J1939)
...
...
Simply connect an appropriate power source to the 4-pin locking connector marked with the power icon 
.
DC Power Cable Part Numbers:
Length | Part Number |
|---|---|
3m (10ft) | 6954.2063 |
4m (13 ft) | 6954.2000 |
4.5m (15 ft) | 6954.2031 |
AC Wall Adaptor Part Number:
Item | Part Number |
|---|---|
CTM-ONE/500 AC wall adaptor | 6954.2019 |
Power for the CTM-500 can be provided via a compatible PoE (802.3 at) power supply. Simply connect the PoE power supply to the ETH0 port of the CTM-500.
Note: PoE functionality is available on the CTM-500 only when the optional battery pack module is installed.
Item | Part Number |
|---|---|
Accessory Battery Pack | 11220.9910 |
...
For mobile applications, the CTM-500 can be powered using the vehicle ECU.
Cable Part Numbers:
...
Length
...
OBDII Part Number
...
...
6954.2002
...
6954.2001
...
4.5m (15 ft)
...
6954.2029
...
6954.2028
...
6m (20 ft)
...
6954.2044
Ignition Cable (optional)
Ignition cable is only required for vehicles that cannot determine the ignition state from the vehicle ECU. Please contact Cypress Solutions at support@cypress.bc.ca for additional information.
...
Length
...
Part Number
...
4.5m (15 ft)
...