...
The wireless gateway can be configured via Ethernet or Wi-Fi, depending on the enabled access in the configuration. By default, local Ethernet access is enabled, and Wi-Fi is disabled. Depending on the initial configuration upon shipment, enabling Wi-Fi access may be optional.
Ethernet
| Note |
|---|
Firmware 1.4.X and later ONLY supports https:// |
...
Ethernet access can be disabled, but before doing so, ensure you have confirmed alternative access via other mechanisms, such as Cypress IOT.
Wi-Fi
Check To check the status of the WiFi LED Wi-Fi access on the modem if possible:
If the Wi-Fi LED is OFF, the WiFi it indicates that Wi-Fi access is disabled.
If the Wi-Fi LED is blinking GREEN then WiFi , Wi-Fi access is avaialable available, but no clients have registered yet.
You will have Wi-Fi access is established when the Wi-Fi LED is solid Green.
The When the CTM-ONE can broadcast its SSID when 's Wi-Fi access point is enabled. Scan , it can broadcast its SSID. You can scan for the SSID and connect to it after entering the Wi-Fi password.
...