The CTM-ONE will be ready for access and configuration approximimately approximately 50 seconds after applying power.
...
The wireless gateway can be configured via Ethernet or Wi-Fi, provided access is enabled in configuration, by default local ethernet depending on the enabled access in the configuration. By default, local Ethernet access is enabled, and WiFi Wi-Fi is disabledisabled. Depending on the initial configuration upon shipment, this step enabling Wi-Fi access may be optional.
Ethernet
| Note |
|---|
Firmware 1.4.X and later ONLY supports https:// |
...
Ethernet access can be disabled, but before doing so, ensure you have confirmed alternative access via other mechanisms, such as Cypress IOT.
Wi-Fi
Check the status of the WiFi LED on the modem if possible
If LED is OFF, the WiFi access is disabled.
If LED is
The CTM-ONE can broadcast its SSID when Wi-Fi access point is enabled. Scan for the SSID and connect after entering the Wi-Fi password.
| Info |
|---|
Depending on the configuration, some units will ship with customer-defined SSID and PSK |
Wi-Fi access can be disabled in the modem configuration if necessary
Refer to the table below for access via username/password.
...
WLAN0 | WLAN1 | Valid |
|---|---|---|
1(AP) | 2(CLIENT) |
|
1 | 1 |
|
2 | 2 |
|
2 | 1 | ❌ |
| Info |
|---|
When configured as both an access point and a client, the Wi-Fi LED will display a blended red/green color. The CTM-ONE has a bi-color LED and cannot accurately represent a green color for access point and a red color for client mode simultaneously. |
...