Quickstart Guide

Connect the hardware

The CTM-ONE will be ready for access and configuration approximately 50 seconds after applying power. The power LED should remain solid green. During boot, the other four LEDs will flash in a left-to-right pattern with blinking red LEDs. Once the blinking stops, the modem is accessible.

Detailed LED status information is available in the CTM-ONE https://cypsolutions.atlassian.net/wiki/spaces/CTMONE/pages/2393604350/LED+Light+Indicators?atlOrigin=eyJpIjoiNDlkMjQ3ZDNkNTdjNDI5YzhjNzM5MjJlNzQyOTdhMTUiLCJwIjoiYyJ9 .

Accessing the CTM-ONE

Upon accessing the CTM-ONE via https://cypsolutions.atlassian.net/wiki/spaces/CTMONE/pages/2393604464/Local+Management?atlOrigin=eyJpIjoiN2E1YjU2OTNkNjkwNDg4YjlkYjFhMjQ2OTAyZjkxOGQiLCJwIjoiYyJ9 , you will be prompted to change your password.

The default password will be provided on the primary label attached to the CTM-ONE.

Your new password must meet the following criteria:

Be at least 8 characters long
Include a combination of letters, numbers, or special characters
Avoid using dictionary words

Wireless Access

Refer to the table below for access via username/password.

Default IP (https)	Default SSID	Key

Default IP (https)

Default SSID

Key

Firmware 1.3.x and earlier:

http://192.168.2.1

CTMONE-[last 4 digits of MAC] for WLAN0 Access Point

CypressAccess

Firmware 1.4.x and later:

https://192.168.3.x (wlan0)

https://192.168.4.x (wlan1)

CTMONE-[last 4 digits of MAC] for WLAN0 Access Point

CypressAccess

The CTM-ONE supports two Wi-Fi interfaces: WLAN0 and WLAN1.

Learn more at https://cypsolutions.atlassian.net/wiki/spaces/CTMONE/pages/2393604464/Local+Management?atlOrigin=eyJpIjoiNzQ4MmQxOWUzMDJjNGUxYmI3YzU5ZTRiMDBjNTM0MDQiLCJwIjoiYyJ9.

You will see this screen after a successful login.

Wired Access

Firmware 1.4.X and later ONLY supports https://

When physically connected via an Ethernet cable, the CTM-ONE web interface is accessible by opening a browser and navigating to either https://192.168.1.1 or, as an alternate address, use https://169.254.0.1.

The default password will be provided on the label attached to the CTM-ONE, as shown above.

By default, the CTM-ONE utilizes DHCP to dynamically assign an IP address to the connected computer. Depending on the configuration of your computer, local network adjustments may be necessary. Please consult your company's IT resources for assistance.

Ethernet access can be disabled, but before doing so, ensure you have confirmed alternative access via other mechanisms, such as Cypress IOT.

Remote access via Cypress IOT

Please log in at https://iot.cypress.bc.ca.

If you don't have Cypress IOT login credentials, please contact Cypress Solutions at support@cypress.bc.ca. You will receive a Cypress IOT activation email to validate your email address.