There are two methods for modem control and configuration
Local Access via web browser
Remote Access via Cypress IOT
Configuration of the CTM-ONE modem is accomplished via a heirarchical web GUI interface. Cypress IOT offers the same heirarchical interface to mimic the experience of being connected locally to the device.
Local Access
Local connection to modem via ethernet cable or via WiFi
Available when the modem does NOT have an active Cellular connection or no SIM installed.
Local Access Pre-requisites
physical access to CTM-ONE
Modem must be configured to accept connection via Local ethernet or WiFi
Connecting computer must allow connections via the LAN /WLAN configuration on the modem
Remote Access
Remote connection to modem via Cypress IOT
Devices regularily “check-in” to Cypress IOT at a user configurable time interval, for example every 900 seconds or 15 minutes.
Device management via Cypress IOT is a Near real-time system for device management based on the programmed “check-in” time above.
After a device check-in to Cypress IOT the device will apply any configuration changes queued for the device via the configuration/command/jobs interface of Cypress IOT
Remote Access Pre-requisites
User must have active Cypress IOT credentials,
Modem must be able to communicate with Cypress IOT via cellular wireless connection.
The CTM-ONE will be ready for access and configuration approximimately 50 seconds after applying power.
After powering on, the CTM-ONE's power LED will remain solid green. During the booting process, the remaining four LEDs will flash in a left-to-right pattern, with blinking RED LEDs. Once the blinking ceases, the modem will be accessible.
The wireless gateway can be configured via Ethernet or Wi-Fi, provided it is enabled. Depending on the initial configuration upon shipment, this step may be optional. Additionally, all configurations can be remotely executed via the Cypress IOT device management platform.