Ethernet
One Ethernet port (bridged/non-bridged)
Ethernet services can be disabled
Ethernet ports can use DHCP or static IP addresses (DHCP can be configured to a single IP address)
Gateway support when an Ethernet port is used to connect to the Internet through another router
Static NAT support
USB OTG (On-The-Go) port
CAN Bus port
8-position interfaces including power
Automotive CAN support (J1939, OBD2/ISO15765-4)
Support for other CAN systems using RAW message type
Silent mode support
2 CAN Interfaces:
1: HS-CAN (J1962 pin 6,14)
2: HS-CAN/MSCAN (J1962 pin 3,11)
Locking 3 Wire power connector with ignition sense
4 pin interfaces
7-32 VDC with transient (spike) protection
.1 to 3 mA @ 12 Volts low power mode (feature dependent)
General Purpose Input and Outputs (GPIO)/Serial/1-Wire® (16 pin). Please refer to Appendix 2: GPIO/RS232/1-Wire Data Cable Connectionfor more detail.
Inputs x4
Outputs x4
R-S232 (Receive/Transmit)
1-Wire® interface
Protected (fused) power output
3 SMA(2x Cell/1xGPS(GNSS)) and 1 RP-SMA (WiFi) RF connectors for external antenna support
Use of external antennas is optional
The CTM-ONE has internal antennas for Cellular/Wi-Fi/GNSS. External antennas can be enabled via software selectable switch