Selecting the configuration tab shows an overview page.
...
| Table of Contents | ||||||||||||
|---|---|---|---|---|---|---|---|---|---|---|---|---|
|
...
apps
Configure custom applications installed on the modem.
gpio
Configure the 4 General Purpose Inputs and Outputs (GPIO).
Ignition wakeup
Input configuration (Analog/digital, Pulse counting)
Output configuration
gps
Configures GPS functionality.
...
Configures parameters for harsh driving detection.
iot
Configure the Cypress IOT client destination URL (do not change) for device management. Adjust the check-in interval based on the speed of updates applied to field devices by Cypress IoT. The default check-in interval is 900 seconds.
Cypress IOT check-in overhead is approximately 10 KB/check-in.
network
Configuration of various modem network settings and wired/wireless interfaces.
...
Configures wireless networks, Bluetooth, Cellular and Wi-Fi.
Report
Configures the modem reporting system of telemetry data.
...
If FIFO reporting is enabled, report messages will be sent to remote destination in chronological order. This can be useful for some systems that have issues working with data that arrives in non-chronological order. If stored data is encountered, there will be a delay of approx 0.5 to 1 sec/stored message before first live message is sent to remote destination server. For example, if the stored buffer has 500 messages, there could be up to a 500 second delay before the first live message shows up after a device has connected after being out of coverage.
If Message ACK is enabled, ACK must be supported by the receiving report destination server. Please contact Cypress Solutions for documentation on ACK protocol.
SYSDB keys with NMEA in the name description are the only keys allowed for Raw NMEA reporting.
Enable report triggering during WAKEUP state should only be enabled if telemetry data is required during modem wakeup for modem management via Cypress IOT (system--> Power Management).
When “Report changed keys only” is enabled, messages are reported on boot, wake and when the key-value changes.
GPS_NMEA_PGPS proprietary message is included automatically when key-value pair report format is selected.
serial
modbus
Modbus is a request-response protocol implemented using a master-slave relationship.
...
Console
Local Report
Modbus
PAD
system
Local authentication
Sets authentication mode for SSH and Web GUI to use local(password) or RADIUS authentication.
...
Configures the source and priority for time synchronization. Options include Cellular-based network time, GPS time, and NTP server time.
vehicle
Two available CAN ports, CAN0 and CAN1, are available for configuration. Ports can automatically detect vehicle type (J1939 or OBDII) or can be manually set. Additionally, a RAW data mode is available for reading other data on the CANbus from third-party systems.
...