| Info |
|---|
In most cases, the device will come with pre-configured, installed SIM(s). If so, SIM card installation is not required. |
The CTM-ONE supports two 2FF style (mini) SIM cards. One or two SIMS can be installed.You can install either one or two SIM cards.
It is advisable to use single-piece SIM cards whenever possible. Many SIM cards today are "tri-cut" to support various SIM card proportions. However, caution must be exercised when using tri-cut SIM cards as the cutaway parts can become dislodged, potentially affecting electrical connectivity between the SIM card and SIM holder.
| Note |
|---|
If a SIM card becomes stuck in the SIM holder, DO NOT attempt to force its removal as this could damage the SIM holder. Please contact Cypress Solutions Support for assistance. In certain instances where the modem fails to detect a SIM card, this may result from manufacturing tolerances of the SIM card. Adding a thin piece of Scotch tape to the backside of the SIM to slightly increase its thickness can aid in ensuring electrical contact with the SIM holder contacts. We can provide SIM tape for this purpose upon request. Read more at SIM Card Taping. |
Installation
...
For single SIM card installation, we recommend using the UPPER it is recommended to use the LOWER slot of the dual-SIM holder. The UPPER LOWER slot is the slot furthest away from the printed circuit boardreferred to as SIM2 slot. The UPPER slot is , referred to as SIM1 slot, is located furthest away from the printed circuit board. The LOWER slot is referred to as SIM2 slot.
In most cases the device will ship with a pre-configured, installed SIM(s). In this case, SIM card installation is not required.
SIM card access is via the removal of
The SIM slots are positioned next to the battery (if battery is installed).
Accessing the SIM card slots requires removing the battery/back cover by removing . To do this, remove the 4 top cover #4-40 socket head cap screws using a 3/32” Allen key driver (supplied).SIM slots are located next to the battery. Be careful
...
| Note |
|---|
Be cautious not to dislodge the battery during SIM removal |
...
or installation. |
Ensure When reinstalling the battery cover, ensure that the gasket is in place when the Battery cover is reinstalled and tighten . Tighten the screws in a xcriss-cross pattern until snug for to achieve an optimal weather-tight seal. Do not overtighten, over tighten; the recommended torque value : is 4-5 in-lbNote: for some applications/configurations .
| Info |
|---|
For certain applications or configurations, the internal battery may not be installed. |
...
After installing the SIM card, if the modem SIM LED is flashing (GREEN if SIM Slot 1 is used or RED if SIM SLOT 2 is used), this indicates that the SIM card is not being detected. Please remove and examine the SIM card, add backing tape as described above, or replace it if the SIM card is still not detected.