Please connect the CTM-500 to a suitable power supply. There are three options for powering the CTM-500:
DC Power supply (refer to appendix for more detail)
DC Power Supply
Power for the CTM-500 can be sourced through an AC/DC wall adapter for continuous operation. Alternatively, a DC power cable can connect to a DC power source within the range of 7-32 VDC. Moreover, ignition line detection is supported, allowing the CTM-500 to transition into standby/suspend modes for low-power scenarios.
Simply connect an appropriate power source to the 4-pin locking connector marked with the power icon 
.
DC Power Cable Part Numbers:
Length | Part Number |
|---|---|
3m (10ft) | 6954.2063 |
4m (13 ft) | 6954.2000 |
4.5m (15 ft) | 6954.2031 |
AC Wall Adaptor Part Number:
Item | Part Number |
|---|---|
CTM-ONE/500 AC wall adaptor | 6954.2019 |
PoE
Power for the CTM-500 can be provided via a compatible PoE (802.3 at) power supply. Simply connect the PoE power supply to the ETH0 port of the CTM-500.
Note: PoE functionality is available on the CTM-500 only when the optional battery pack module is installed.
Item | Part Number |
|---|---|
Accessory Battery Pack | 11220.9910 |
Vehicle ECU
For mobile applications, the CTM-500 can be powered using the vehicle ECU.
Cable Part Numbers:
...
Length
...
J1939 Part Number
...
OBDII Part Number
...
2m (6ft)
...
6954.2002
...
6954.2001
...
4.5m (15 ft)
...
6954.2029
...
6954.2028
...
6m (20 ft)
...
6954.2044
Ignition Cable (optional)
Ignition cable is only required for vehicles that cannot determine the ignition state from the vehicle ECU. Please contact Cypress Solutions at support@cypress.bc.ca for additional information.
Length | Part Number |
|---|---|
4.5m (15 ft) | 6954.2052 |